OggPCM

Alternate format for OggPCM

The following is an alternate format for OggPCM. This is a work in progress and not a final proposal.

Note that unless otherwise noted, all multi-byte fields use the network byte order (big endian). The first packed in a stream MUST be the main header packet. The second packet MUST be the comment packet. Some extra header packets MAY be included after the comment header, provided this is identified in the main header. The packets that follow MUST all be data packets.

Main Header Packet

Multibyte fields in the header packets are packed in big endian order, to be consistent with network byte order. A header packet contains the following fields:

32  "PCM"  Codec identifier ("PCM\0\0\0\0\0"?)
16  0x00   Version Major (breaks backwards compatability to increment)
16  0x00   Version Minor (backwards compatable, ie, more supported format id's)
32  [uint] PCM format
32  [uint] Significant bits
32  [uint] Sampling rate [Hz]
32  [uint] Number of Channels (< 256)
16  [uint] Maximum number of frames per packet
16  [uint] Number of extra header packets

A PCM "frame" is composed of samples for all channels at a given time.

The "Maximum number of frames per packet" field is meant to notify an application reading the file that no data packet will contain more than a certain number of frames. This not only makes implementation easier, but also provides information on how much needs to be buffered when streaming PCM files. A value of 0 means a maximum of 65536 frames. Implementations SHOULD make this field such that packets do not get split into multiple pages.

The "significant bits" field specifies how many bits are actually used. The other bits MUST be zero. This can be used to support audio with any resolution. For example, 12-bit PCM can be supported as "16 bit PCM" for the format and 12 for the number of significant bits.

For streams where the number of significant bits is the same as the bit width specified by the format, the significant bits field may be set to zero.

For streams where the number of significant bits is less than that specified by the bit width, the data shall be justified to fill the most significant bits. For 12 bit PCM in a 16 bit format, the 12 valid bits will occupy the 12 most significant bits of the 16 bit word and the least significant 4 bits shall be zero.

Since the main header packet and the comment packet are mandatory, the "extra header packets" field counts any additional header packets (aside from these two) that can be provided before the start of the data packets.

Comment packet

The codec header is followed by a "vorbis comment" packet and by optional extra headers, if any. The format used is the same as for Vorbis with the exception that there is no packet identifier (so the packet is exactly like it is for Speex).

Extra Headers (optional)

Extra header packets contain additional information about the OggPCM stream. Each extra header is defined as:

32  [uint] Header ID
...        Header data

Two examples for such extra header packets are the channel mapping and the channel conversion header packets.

Channel Mapping Header

The channel mapping header is defined as:

32 0x00000000   Header ID
16 [uint]   Major version
16 [uint]   Minor version
32 [uint]   Channel type
32xN [uint] Channel map (one for each channel)

As an example, stereo might be encoded as:

channel_type = OGG_CHANNEL_MAP_STEREO
channel_map [0] = OGG_CHANNEL_STEREO_LEFT
channel_map [1] = OGG_CHANNEL_STEREO_RIGHT

or as:

channel_type = OGG_CHANNEL_MAP_STEREO
channel_map [0] = OGG_CHANNEL_STEREO_RIGHT
channel_map [1] = OGG_CHANNEL_STEREO_LEFT

All channel_types less than 0x80000000 are reserved for use by Xiph and all the ones above are allowed for application specific extensions.

Channel Conversion Header

Any number of channel conversion headers can be specified. This header specifies how to down-mix the data to another format.

32 0x00000001 Remixing Header Id
16 [uint]     Major version
16 [uint]     Minor version
32 [uint]     Target Channel type
32xMxN [sint] Target Channel (M) x Src Channel (N) Gain array

The ordering of the mixing matrix is such that source channel gains are consecutive. The gain (note: *signed* integer) has the 16 MSBs for the integer part (including sign) and 16 bits for the fracional part of the gain. Note: the gain can be negative.

Data Packets

Data packets contain the raw PCM audio in interleaved format (complete frames are encoded sequentially) with the following definitions/restrictions:

• A PCM "frame" is composed of samples for all channels at a given time.
• Any OggPCM packet should only contain complete frames (ie samples for all channels at a given sampling instance). Partial frames are forbidden.
• There is no padding allowed in a frame except when some bits (<8) are needed to complete a byte. This means that packet size has a direct relationship to the number of frames in the packet (for purposes of seeking).
• Recommended packet size is smaller than 4k since interleaving and seeking in Ogg bitstreams is done on the resolution of packets and thus larger packet sizes create suboptimal bitstreams.

Supported PCM Formats

Format ID  Short Name             Description
 -- Integer coding
 0x00000000    OGGPCM_FMT_S8          Signed integer 8 bit
 0x00000001    OGGPCM_FMT_U8          Unsigned integer 8 bit
 0x00000002    OGGPCM_FMT_S16_LE      Signed integer 16 bit little endian
 0x00000003    OGGPCM_FMT_S16_BE      Signed integer 16 bit big endian
 0x00000004    OGGPCM_FMT_S24_LE      Signed integer 24 bit little endian
 0x00000005    OGGPCM_FMT_S24_BE      Signed integer 24 bit big endian
 0x00000006    OGGPCM_FMT_S32_LE      Signed integer 32 bit little endian
 0x00000007    OGGPCM_FMT_S32_BE      Signed integer 32 bit big endian
 --
 -- Compressed PCM
 0x00000008    OGGPCM_FMT_ULAW        G.711 u-law encoding (8 bit)
 0x00000009    OGGPCM_FMT_ALAW        G.711 A-law encoding (8 bit)
 0x0000000A    OGGPCM_FMT_ULAW12      Wideband u-law encoding (12 bit)
 0x0000000B    OGGPCM_FMT_ALAW12      Wideband A-law encoding (12 bit)
 --
 -- IEEE Floating point coding
 0x00000010    OGGPCM_FMT_FLT32_LE    IEEE Float [-1,1] 32 bit little endian
 0x00000011    OGGPCM_FMT_FLT32_BE    IEEE Float [-1,1] 32 bit big endian
 0x00000012    OGGPCM_FMT_FLT64_LE    IEEE Float [-1,1] 64 bit little endian
 0x00000013    OGGPCM_FMT_FLT64_BE    IEEE Float [-1,1] 64 bit big endian

Related Links

Short info about AC-3: http://www.mediatwins.com/en/support/kb_topic_11.html

AC-3 spec: http://www.atsc.org/standards/a_52a.pdf
Note: around p34/140 it appears to be how the channel mapping is encoded.

.wav extended headers for multi channel: http://www.microsoft.com/whdc/device/audio/multichaud.mspx

General surround info: http://www.surroundassociates.com/fqmain.html