OggCELT

CELT is an experimental audio codec for use in low-delay communication.

The name stands for "Code-Excited Lapped Transform". It applies some of the CELP principles, but does everything in the frequency domain, which removes some of the limitations of CELP.

The CELT codec is meant to close the gap between Vorbis and Speex for applications where both high quality audio and low delay are desired. It is a

Current features include:

• Ultra-low latency (typically from 3 to 9 ms)
• Full audio bandwidth (44.1 kHz and 48 kHz)
• Stereo support
• Packet loss concealment
• Constant bit-rates from 32 kbps to 128 kbps and above
• A fixed-point version of the encoder and decoder

The CELT homepage has all additional info as well as samples.

CELT Tuning

CELT currently provides three types of tuning knob.

Frequency-dependent bit allocation

This is by far the most important thing to tune. There's a matrix in modes.c called "band_allocation". It has BITALLOC_SIZE lines and BARK_BANDS columns. Each line determines how many bits will be allocated to each critical band depending on the number of bits available.

Even in CBR mode (the only mode currently supported) the available number of bits will change from frame to frame because the space consumed by the compressed spectral envelope is not constant. However, at a single constant bitrate the available number of bits does not change tremendously much from frame to frame, as a result most of the values in the matrix will have little to no effect at any particular bit-rate setting.

The particular bit-rate that a line is used for is not explicitly specified but is instead inferred by the actual bit consumption of that line.

When the amount of bits available is somewhere between the amounts provided by explicitly configured lines the encoder will interpolate between the two nearest matching lines to achieve the needed bit-rate.

Minimum width of bands

At low frequencies, critical bands are too narrow to be useful, so CELT imposes a minimum width for the bands. The minimum width is (in MDCT frequency bins) is defined by MIN_BINS in modes.c. The trade off is that for small values, there will be more bands, so more energy data to encode, while for large values, there may not be enough resolution to encode the spectral shape properly.

Energy encoding resolution

The last set of parameters is the resolution at which the energy is encoded. The trade off here is that any bit spent on encoding the energy more accurately isn't spent on the residual signal in 1). The resolution is defined in the "frac" array in quant_bands.c. The values themselves are the number of subdivisions to use in 6 dB, i.e. for band i, the resolution used is 6/frac[i] dB. So the higher the value, the more accurate the encoding and the more bits it takes.

Ogg mapping (experimental)

Default field type: LITTLE ENDIAN unsigned integer

  0                   1                   2                   3
  0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1| Byte
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | codec_id: Identifier char[8]: 'CELT    '                      | 0-3
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 |                                                               | 4-7
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | codec_version: char[20]                                       | 8-11
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 |                                                               | 12-15
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 |                                                               | 16-19
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 |                                                               | 20-23
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 |                                                               | 24-27
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | version_id                                                    | 28-31
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | header_size                                                   | 32-35
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | mode                                                          | 36-39
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | sample_rate                                                   | 40-43
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | nb_channels                                                   | 44-47
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | bytes_per_packet                                              | 48-51
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
 | extra_headers                                                 | 52-55
 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+